US3074243A - Vortex water cooler - Google Patents

The inlet could be room temperature, whereas the cold outlet could be in a cooler basement, which I would think would cause the draw to pull from the room, not the cellar. A vortex tube creates a vortex and separates it into two air streams-one hot and one cold. In the cab of the usual steam locomotive there could be found a bucket of water for drinking purposes, and sometimes this bucket would have some ice provided in it at the beginning of a run.

Vortex Water

Cold Fraction The percentage of total input air volume released through the cold air exhaust of a Vortex Tube is called the Cold Fraction. Doing this below ground is a good idea, and you should try it on a small scale before investing too much into it.

Although the phenomenon is fairly complex to understand but an attempt has been made herein to explain the functionality of vortex tube in the most simplest terms possible. The exhaust line 25 from the heat exchanger 12 is shown connected to the skirt 29 so that the relatively cool exhaust air can be introduced into the skirt around the hot tube Boost this thread!

Concept - Raising Food the Right Way.

Vortex Tubes

These amazing new pressure tanks make entirely new transportation systems feasible, whereas in the past, high pressure tanks made of steel were far too heavy to be practical for these applications. Next step: Ok, enough with theory, let's make some hands on reality! New Time left: Remember too that the greater our distribution network the greater our storage think black poly pipe and if that pipe is getting heated in the sun even better as we get more bang for our buck due to the increased pressure from the heated air not to mention that unlike water we dont need to pump it up hills or such as it effectively has little weight.

The spiraling air is forced down the inner walls of the hot tube at speeds reaching 1,, rpm.

cooling with a vortex tube (energy forum at permies)

Now, just attach the ball valve on the end of the hot pipe if it's snug, you probably could go without gluing it oh, and rig up the air lines! FIGURE 2 is an enlarged detail view of the vortex tube employed to produce the cold air for refrigeration;. These ideas, as well as maxwell's thoughts on the subject came to Rudolf Hilsch and he began actually researching and building a refrigerant system to try and beat the standard system for the German military.

I was out for a few days A boulder and ping pong ball are rolling towards it.

The Hilsch Vortex Tube : 11 Steps (with Pictures)

Using only filtered, factory compressed air as a power source, they convert ordinary compressed air into two air streams -- one hot and one cold. WOA1 en. This is not "low tech" or "old tech" that has no current value; quite the opposite. Now a question on your comment on a treadle pump. I'm looking into the vortex tube coolers and the fact that they are inefficient does not bother me if the power source is solar.

Finally the geology is such that the water that melts off the cliff runs down into the cave to be frozen. This will apply whether sun heating air or if your air source is hot going into the pipe.

The Ranque-Hilsch Vortex Tube - Synergy Files

This would also probably help water and snow fall in. And think what can be done with the difference between hot and cold, hint hint. In a forced vortex, the velocity is directly, proportional to the radius of the vortex-the closer the center, the slower the velocity.